Please check trademe link for more pictures https://www.trademe.co.nz/2278387966
This Plasma / Router table is a unique one of a kind setup that can run off a single phase supply
The machine itself is an MX-3 made by Vertigo technologies NZ ,it uses lead screws rather than belts which results in better accuracy and great cut control.Maximum feed-rate of 4000 mm/min spare parts are readily available if required.
The Plasma adaptation is my own design and works really well and was the main reason i bought the machine. The design makes it easy to switch between a router and plasma within a few minutes. The plasma table is easy to maintain with the rails simply lifting out , there is a ceramic board at the bottom of the trey that protects the surface of the vacuum table used for the router.
The table is ventilated which provides adequate cooling and removes 90% of the cutting fumes , the plasma cutter itself is a hypertherm powermax 30 xp with pilot arc, I cannot stress enough how good the cut quality is for a plasma, I have cut .55mm to 8mm steel on this machine and it does a great job, the manual for the plasma says it is capable of cutting 16mm steel.
I have used the machine for around 8 months to create artwork and practical profile cutting as a hobby however i now have access to a laser cutter so i no longer need it.
The setup will come with all of the ducting and wiring needed to run it , it only requires a modest computer with some free-ware programs to run it , which i will be happy to show the buyer what to do .I intend on keeping the compressor but may negotiate depending on the buyer.The machine also comes with a small laser which can be used to cut thin materials or mark wood etc.
I can deliver within christchurch , or pickup is available from woolston Chch
Happy to answer any questions or demonstrate its abilities to a potential buyer